Gas water heating system On YouTube.
Find out how to replace a gas water heater with step by step instructions in this video. You need a wrench and other tools common pipes. You also need a pipe joint compound or Teflon ® tape. You can make a solution of detecting gas leaks or bubbles with the children. For copper, you can use a kit that no welding. First make sure that the gas supply was switched off and the knob. Let the hot water until cold.Let the water from the hot water tank. Remove the pressure line from the old temperature and pressure relief valve. Disconnect the vent pipe and the pipe union and remove the gas. If the pipe welding, not welded, while they are mounted on the water heater. Instead, solder, an adapter and install the adapter with pipe joint compound or Teflon tape ®. Install a thermal expansion tank. Check the water pressure at home. Replace the printer cable. Not that the cap of the drain line.Install the new design cap and insert the vent tube. Install the gas line. Turn the gas supply and check for leaks. Correct any leaks and try again. Turn on cold water and check for water leaks. Open a hot water faucet and let the water run for 3 minutes full. Install the air filter and the vacuum from time to time. Birth to a hot water heater, turn the knob to pilot and push the button completely. Hold down the button and click the trigger once per second, until the status LED startsfor ...
Keywords: Gas Water Heater Installation, installing a gas water heater, gas water heater, gas hot water heater, hot water heater, water heater, lowes, lowe's, water heater installation, instructions, how to
No comments:
Post a Comment